Diamond & CBN honing stone :

The dimension of the honing stone depends on the design of the honing holder / mandrel. In particular, the height of the abrasive layer is defined by the I possible infeed path of the holder. For the sake of clarity, some type of honing stones are given as below :

 

Standard honing stone

Honing stones having abrasive layer on steel base. Honing stone is soldered on honing shoe / carrier.

To write dimension: W X H X L X A

Slotted standard honing stone

Same as standard honing stone but with a slot longitudinally for better cutting, cooling and chip removal.

To write dimension: W X H X L X AS

Solid honing stone

This stone consists only the abrasive (No steel base) and is also soldered on the honing shoe / carrier or holder segment.

To write dimension: W X H X L X A

 

Compact honing stone

 

Honing stones for direct fitting into the body of the honing holder. This type of stone is generally used for very small bore honing.

To write dimension: W X H X L X A

Drawing of the stone required for manufacturing.

W = Width (mm) H = Height (mm)

L = Length (mm) A = Abrasive height (mm)

S = Slot width (mm)

 

Solutions Better Use

Various influences determine the result of the honing The characteristics of a honing stone as well as a fine tuning of all the different parameters make it possible to achieve the required result. In addition to high quality in manufacturing, both a short processing time and a long life of the stones can be achieved. The selection of the

 

Applications:

 

These are useful for mainly cast iron applications, super finishing cases, carbide honing, S.G. Iron and other alloy applications & non ferrous products.